In This Guide - Agilent Technologies U2000 Series Manual

In This Guide ...

vi
Power Sensor Remote Operation
1
that configure the power sensor and helps you determine settings to
optimize performance.
MEASurement Commands
2
group of instructions to acquire data using a set of high level instructions.
CALCulate Subsystem
3
subsystem is used to perform post acquisition data processing.
CALibration Subsystem
4
command subsystem is used to zero and calibrate the power sensor.
FORMat Subsystem
5
used to set a data format for transferring numeric information.
MEMory Subsystem
6
subsystem is used to create, edit and review sensor calibration tables.
SENSe Subsystem
7
subsystem directly affects device specific settings that are used to make
measurements.
SERVice Subsystem
8
subsystem is used to obtain and set information useful for servicing the
power sensor.
STATus Subsystem
9
subsystem enables you to examine the status of the power sensor by
monitoring the "Device Status Register", "Operation Status Register" and
the "Questionable Status Register".
SYSTem Subsystem
10
subsystem is used to return error numbers and messages from the power
sensor, preset the power sensor, and query the SCPI version.
TRIGger Subsystem
11
subsystem is used to synchronize device actions with events.
Chapter 1 describes the parameters
Chapter 2 explains how to use the MEASure
Chapter 3 explains how the CALCulate
Chapter 4 explains how the CALibration
Chapter 5 explains how the FORMat subsystem is
Chapter 6 explains how the MEMory command
Chapter 6 explains how the SENSe command
Chapter 6 explains how the SERVice command
Chapter 7 explains how the STATus command
Chapter 8 explains how the SYSTem command
Chapter 9 explains how the TRIGger command
U2000 Series Programming Guide