Initiate[1]:Continuous <Boolean - Agilent Technologies U2000 Series Manual

INITiate[1]:CONTinuous <boolean>
This command sets the power sensor for either a single trigger cycle or
continuous trigger cycles. A trigger cycle means that the power sensor exits
the wait for trigger state and starts a measurement.
If INITiate:CONTinuous is set to:
• OFF, the trigger system remains in the idle state until it is set to ON, or
• ON, the trigger system is initiated and exits the idle state. On completion of
This command performs the same function as INITiate:CONTinuous:SEQuence[1]
N O T E
<boolean>.
Syntax
U2000 Series Programming Guide
INITiate:IMMediate is received. Once this trigger cycle is complete the
trigger system returns to the idle state.
each trigger cycle, the trigger system immediately commences another
trigger cycle without entering the idle state.
INIT :CONT
1
Space
0|OFF
1|ON
?
TRIGger Subsystem
265
11