Sense[1]:Average Commands - Agilent Technologies U2000 Series Manual

7 SENSe Subsystem

SENSe[1]:AVERage Commands

These commands control the measurement averaging which is used to improve
measurement accuracy. They combine successive measurements to produce a
new composite result.
The following commands are detailed in this section:
SENSe[1]:AVERage:COUNt <numeric_value>
SENSe[1]:AVERage:COUNt:AUTO <boolean>
SENSe[1]:AVERage:SDETect <boolean>
SENSe[1]:AVERage[:STATe] <boolean>
162 U2000 Series Programming Guide