6
MEMory Subsystem
MEMory:TABLe:GAIN[:MAGNitude]
<numeric_value>{,<numeric_value>}
This command is used to enter offsets into the frequency dependent offset
table, currently selected using MEMory:TABLe:SELect. Any previous offset list
is cleared before the new offsets are stored.
A maximum of 80 parameters for frequency dependent offset tables can be
sent with this command.
Entries in the frequency lists correspond as shown in
the offset factor lists.
Table 6-2 Frequency and Offset Factor List
152
Frequency
Frequency 1
"
Frequency 80
Table 6- 2
with entries in
Offset
Offset 1
"
Offset 80
U2000 Series Programming Guide