2. Install the control valve body component.
Tightening torque
7.810.8 N·m
{80110 kgf·cm, 7095 in·lbf}
Bolt length (measured from below the head)
B: 40 mm {1.575 in}
No mark: 70 mm {2.756 in}
3. Install the oil strainer.
4. Match the harness colors, then connect the
solenoid connector and TFT sensor connector.
Spring
Pressure control solenoid
Shift solenoid A
Shift solenoid B
Shift solenoid C
Shift solenoid D
Shift solenoid E
5. Install the ground.
Tightening torque
7.810.8 N·m {80110 kgf·cm, 7095
in·lbf}
6. Apply a light coat of silicon sealant to the contact
surfaces of the oil pan and transale case.
7. Install the oil pan.
Tightening torque
68 N·m {6281 kgf·cm, 5370 in·lbf}
8. Install the crossmember. (See
CROSSMEMBER
REMOVAL/INSTALLATION.)
9. Install the front tires and splash shield.
10. Install the under cover.
11. Connect the negative battery cable.
12. Add ATF and with the engine idling, inspect the
ATF level. (See
K13 AUTOMATIC TRANSAXLE
FLUID (ATF)
REPLACEMENT.)
13. Carry out the mechanical system test. (See
14. Carry out the road test. (See
End Of Sie
OIL COOLER FLUSHING
Note
• The contaminated cooler line (oil pipes and hoses) and auiliary cooler must be flushed completely when
ATX is overhauled or replaced.
K36
AUTOMATIC TRANSAXLE
Color of connector
(harness side)
Black
White
Blue
Green
white
Black
R23 FRONT
K6 MECHANICAL SYSTEM
K9 ROAD
TEST.)
TEST.)
A6E5614W062
A6E5614W063
A6E5614W064
A6E561419900W01