Actuator Cable Removal - Mazda 6 2002 Workshop Manual

Terminal Signal
Cruise control
J
switch position
K Brake switch on/off Brake switch 2
L IG1
End Of Sie

ACTUATOR CABLE REMOVAL

1. Remove the plug hole plate.
2. Remove the cover from the cruise actuator. (See
3. Remove the installation nut and pull the cruise actuator toward you.
4. Move the throttle, and remove the end fitting of
the actuator cable from the throttle.
5. Squeeze the hooks of the grommet, and remove
the actuator cable.
T–112
CRUISE CONTROL SYSTEM
Connected to
Cruise control Inspect for
switch resistance
Ignition switch
at ON position
Ignition switch at ON position
METER IG 15 A
Ignition switch at LOCK
fuse
position or ACC position
Test condition
Cruise control
main switch
held at on
SET/COAST
switch held at
on
RESUME/
ACCEL switch
held at on
CANCEL
switch held at
on
Depress brake
pedal
Other
T–110 CRUISE ACTUATOR
Voltage (V)
Action
/Continuity
0 ohm
• Inspect cruise control
Appro.
switch
680 ohms
(See T–116 CRUISE
CONTROL SWITCH
INSPECTION)
Appro.
• Inspect related
2200 ohms
harness
Appro.
120 ohms
• Inspect brake switch 2
Below 1.0
(See P–8 BRAKE
SWITCH
INSPECTION)
B+
• Inspect related
harness
B+ • Inspect METER IG 15
A fuse
• Inspect related
Below 1.0
harness
REMOVAL/INSTALLATION.)
A6E812866311W01
A6E8128W007