Mazda 6 Installation Instructions Manual

GENUINE Remote engine start
INSTALLATION INSTRUCTIONS
Thank you for purchasing a genuine Mazda accessory.
Before removal and installation, be sure to thoroughly read these instructions.
Please read the contents of this booklet in order to properly install and use the Remote engine
start. Your safety depends on it.
Keep these instructions with your vehicle records for future reference.

There are several
installing or removing the Remote engine start. Always read and follow them in order to prevent injuries,
accidents, and possible damage to the vehicle.
WARNING:
Indicates a situation in which serious injury or death could result if the warning
is ignored.
CAUTION:
Indicates a situation in which bodily injury or damage to the vehicle could result if the
caution is ignored.

For areas indicating the tightening torque in this instruction manual, tighten to the specified torque using
a torque wrench. For areas in which the tightening torque is indicated inside parentheses ( ), the
tightening torque is indicated as a reference value, however tightening using a torque wrench is not
necessary.
 Do not modify the Remote engine start.
 Do not install the Remote engine start in any way other than described in the following instructions.
 If in any doubt, please ask your Mazda dealer to install the accessory in order to prevent errors in
installation.
 If you have any questions about the use of the accessory, ask your Mazda dealer for proper advice
before using it.
 Mazda and its suppliers are not responsible for injuries, accidents, and damage to persons and property
that arise from the failure of the dealer or installer to follow these instructions.
 To ensure safety and reliability of the work, installation, removal and disposal work must carried out by
an Authorized Mazda Dealership.
 Be careful not to lose removed parts, and be sure that they are kept free from scratches, grease or
other dirt.
PART NAME:
VEHICLE:
PART NUMBER:
NOTE
To the dealer
 Please turn over these instructions to the customer after installation.
To the customer
 Keep these instructions after installation. The instructions may be necessary
for installing other optional parts or removal of this accessory.
 Should the vehicle or this accessory be resold, always leave these instructions
with it for the next owner.
 When the remote engine start is removed, clear the remote engine start
information programmed to the vehicle by following the clearing procedure for
the advanced key in the workshop manual. In addition, after clearing, the
advanced key has to be programmed again.
WARNING
WARNING and CAUTION sections in this booklet concerning safely when
Remote engine start
MAZDA6
C930 V7 620 (CONTROLLER KIT)
GJR9 V7 630 (HARNESS KIT)
［KD53 V7 629 (Hood Switch)］
1
ZZ092-00691-00
(ZZ092-00690-00)