Diagnostic Monitoring Test Results - Mazda 6 2002 Workshop Manual

For MTX
Shift Vehicle Speed
Zone
Position
O Neutral
A 2nd 40—50 {25—32}
B 3rd 65—75 {41—47}
C 2nd 60—75 {38—46}
D 3rd 75—100 {47—62}
E 4th 50—75 {31—46}
F 5th 75—100 {47—62}
For ATX
Vehicle Speed
Zone Range
km/h {mph}
O P or N
A S (HOLD) 40—65 {25—41}
B D (HOLD) 65—100 {40—62}
C S (HOLD) 60—75 {38—46}
D D (HOLD) 85—100 {52—62}
E D (HOLD) 50—75 {31—47}
F D 75—100 {46—62}
5. Stop vehicle and access to ON BOARD SYSTEM
READINESS menu of GENERIC OBD
FUNCTION to inspect the Drive Mode completion
condition. If completed, RFC changes from NO to
YES.
6. If not completed, turn the ignition key to OFF,
then go back to Step 4.
7. Access DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD FUNCTIONS to inspect the
monitor results. If MEAS are not within the specification, repair has not completed.
8. Verify no DTC is available.
End Of Sie

DIAGNOSTIC MONITORING TEST RESULTS

• The purpose of this test mode is to confirm the result of OBD monitor diagnostic test results. The result values
stored when particular monitor is completed are displayed. If the monitor is not completed, initial value is
displayed.
TEST ID
10:01:0A Rich to lean sensor threshold voltage
10:02:0A Lean to rich sensor threshold voltage
10:03:0A Low sensor voltage for switching time calculation
10:04:0A High sensor voltage for switching time calculation
10:05:10 Rich to lean sensor switching time
10:06:10 Lean to rich sensor switching time
10:0A:10 Sensor period
10:80:20 Front and rear HO2S switching time ratio
End Of Sie
ON-BOARD DIAGNOSTIC
Time
km/h {mph} Sec.
0 {0} T1: Above 455
T2: Above 30
T3: Above 20
T4: Above 120
Time
Sec.
T1: Above
0 {0}
455
T2: Above 30
T3: Above 20
T4: Above
120
Description
A6E3970W004
A6E3970W005
A6E397018881W10
Related system
HO2S
TWC
F–65
F