End Of Sie
JOINT SHAFT PRE-INSPECTION
1. Verify that the joint shaft is not twisted or cracked.
• Replace it as necessary.
2. Turn the joint shaft by hand and verify that the
bearing rotates smoothly and freely.
• Replace it as necessary.
End Of Sie
JOINT SHAFT REMOVAL/INSTALLATION
Caution
• • • • Performing the following procedures without first removing the ABS wheel-speed sensor may
possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the
following procedures, remove the ABS wheel-speed sensor and fi it to an appropriate place
where the sensor will not be pulled by mistake while the vehicle is being serviced.
1. Drain the transale oil. (See
(See
J3 TRANSAXLE OIL
2. Remove the ABS sensor.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
.
M12
DRIVE SHAFT
DRIVE SHAFT
K13 AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT.)
(SeeP32 FRONT ABS WHEEL-SPEED SENSOR
A6E631625700W01
A6E631625700W02
REPLACEMENT.)
REMOVAL/INSTALLATION.)
A6E0313W015
A6E0313W016