Pre-Tensioner Seat Belt - Mazda 6 2002 Workshop Manual

Hide thumbs Also See for 6 2002:

Table of Contents

9. Press the activation switch on the SST

(Deployment tool) to deploy the curtain air bag

Pre-tensioner seat belt

1. Remove the B-pillar lower trim.

2. Remove the pre-tensioner seat belt and connect

the SST (Adapter harness) to it as shown in the

figure. (See

S–100 FRONT SEAT BELT

REMOVAL/INSTALLATION.)

3. Install the pre-tensioner seat belt.

4. Connect the SST (Deployment tool) to the SST

(Adapter harness).

5. Connect the red clip of the SST (Deployment tool)

to the positive battery terminal and the black clip

to the negative battery terminal.

6. Verify that the red light on the SST (Deployment

tool) is illuminated.

7. Make sure all persons are standing at least 6 m

{20 ft} from the vehicle.

8. Press the activation switch on the SST

(Deployment tool) to deploy the pre-tensioner

Deployment Procedure for Outside of Vehicle

1. Inspect the SST (Deployment tool). (See

2. Turn the ignition switch to LOCK position.

3. Disconnect the negative battery cable and wait for more than 1 minute.

4. Follow the appropriate procedure for deploying the driver-side air bag module, passenger-side air bag module,

side air bag module, curtain air bag module, or pre-tensioner seat belt.

AIR BAG SYSTEM

T–140 INSPECTION OF SST (DEPLOYMENT

Table of Contents