Master Cylinder Disassembly/Assembly - Mazda 6 2002 Workshop Manual

6. Install the master cylinder to the power brake unit.
Caution
• • • • If after installing the master cylinder, air
does not bleed properly from the brake
lines even after performing air bleeding,
brake drag occurs or other
characteristics are present, it is possible
that the master cylinder piston is jammed
against the power brake unit. If air cannot
be bled properly, brake drag eists or
other malfunctions occur, remove the
master cylinder and reinstall properly.
FLUID LEVEL SENSOR INSPECTION
End Of Sie
1. Disconnect the negative battery cable.
2. Disconnect the sensor connector.
3. Inspect for continuity between terminals of fluid level sensor.
• If not as specified, replace the fluid level sensor.
End Of Sie

MASTER CYLINDER DISASSEMBLY/ASSEMBLY

Caution
• • • • If the master cylinder body is damaged, replace the unit as a component. When securing the
master cylinder in a vise, tighten only the flange of the master cylinder.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
.
1 Cap set
P–12
CONVENTIONAL BRAKE SYSTEM
A6E6912W024
2 Screw
A6E6912W032
A6E691243540W01
A6E6912W023
A6E691243400W02
A6E6912W019