Idle speed (LF engine ATX model)
Condition
No load
2
Electrical loads*
ON
P/S ON
A/C ON and refrigerant
pressure switch (middle) OFF
A/C ON and refrigerant
pressure switch (middle) ON
Idle speed (L3 engine model)
Condition
No load
2
Electrical loads*
ON
P/S ON
A/C ON and refrigerant
pressure switch (middle) OFF
A/C ON and refrigerant
pressure switch (middle) ON
*1 : Ecludes temporary idle speed drop just after the electrical loads are turned on.
*2 : Blower motor is operating at high speed. Headlight switch is turned on. Rear window defroster switch is turned
on. Cooling fans are operating.
End Of Sie
IDLE MIXTURE INSPECTION
1. Turn off the electrical loads.
2. Warm up the engine as follows.
(1) Start the engine.
(2) Maintain the engine speed at appro. 3,000 rpm until the cooling fans start to operate.
(3) Release the accelerator pedal.
(4) Wait until the cooling fans stop.
3. Verify that the idle speed and ignition timing are within the specification. (See
(See
F8 IGNITION TIMING
4. Insert an ehaust gas analyzer to the tailpipe.
5. Verify that the CO and HC concentrations are within the regulation.
End Of Sie
ENGINE TUNE-UP
1
Engine speed (rpm)*
650750
650750
650750
650750
700800
1
Engine speed (rpm)*
600700
650750
650750
700800
700800
INSPECTION.)
A6E390802000W03
F8 IDLE SPEED
INSPECTION.)
F
F9