Mazda 6 2002 Workshop Manual page 985

6. Connect the SST (Deployment tool) to the SST
(Adapter harness).
7. Connect the red clip of the SST (Deployment tool)
to the positive battery terminal and the black clip
to the negative battery terminal.
8. Verify that the red light on the SST (Deployment
tool) is illuminated.
9. Make sure all persons are standing at least 6 m
{20 ft} away from the vehicle.
10. Press the activation switch on the SST
(Deployment tool) to deploy the driver-side air
bag module.
11. Disconnect the SST (Deployment tool) from the
SST (Adapter harness).
12. Connect the SST (Deployment tool) to the SST
(Adapter harness).
13. Perform steps 7 through 10, in order to deploy the
driver-side air bag module.
Passenger-side air bag module
Warning
• • • • Passenger-side air bag module is the dual inflator type. When the inflators are forced to be
deployed simultaneously, one of them may fail to deploy. When disposing the air bag module, the
inflators may be deployed accidentally. Make sure to deploy the inflators sequentially, following
the procedures below.
1. Remove the passenger-side air bag module. (See
INSTALLATION.)
2. Install the bolts to the passenger-side air bag
module.
3. Connect the SST (Adapter harness) to the
passenger-side air bag module as shown in the
figure.
AIR BAG SYSTEM
T–121 PASSENGER-SIDE AIR BAG MODULE REMOVAL/
A6E8130W032
A6E8130W028
T
A6E8130W035
A6E8130W015
T–133