3. Disconnect the transale connector.
4. Measure the resistance between the terminals E
and H.
• If it is out of specification, perform the off-
vehicle inspection of TFT sensor. (See
TRANSAXLE FLUID TEMPERATURE (TFT)
SENSOR
REMOVAL/INSTALLATION.)
ATF temperature (° ° ° ° C {° ° ° ° F})
20 {4}
0 {32}
20 {68}
40 {104}
60 {140}
80 {176}
100 {212}
120 {248}
130 {266}
5. Install the air cleaner component. (See
6. Connect the negative battery cable.
Off-Vehicle Inspection
Warning
• • • • When the transale and ATF are hot, they can badly burn. Turn off the engine and wait until they
are cool before replacing ATF.
1. Remove the control valve body. (See
2. Remove the transale connector.
3. Remove the TFT sensor from the strainer, and
connect it to the transale connector.
4. Place the TFT sensor and a thermometer in ATF
as shown, and heat the ATF gradually.
K20
AUTOMATIC TRANSAXLE
K21
Resistance (kilohm)
236324
84.3110
33.542.0
14.717.9
7.088.17
3.614.15
1.962.24
1.131.28
0.870.98
F10 INTAKE-AIR SYSTEM
K34 CONTROL VALVE BODY
REMOVAL/INSTALLATION.)
REMOVAL.)
A6E5614W021
A6E5614W022
A6E5614W023