Dual Proportioning Valve - Mazda 6 2002 Workshop Manual

DUAL PROPORTIONING VALVE INSPECTION (WITHOUT ABS)
1. Connect the SSTs to the brake pipes as shown in
the figure.
2. Bleed the air from the brake system.
3. Measure the fluid pressure of the master cylinder
and the rear brake.
• If not within the specification, replace the dual
proportioning valve.
Fluid pressure
A
2,450 {25, 355}
DUAL PROPORTIONING VALVE REPLACEMENT (WITHOUT ABS)
End Of Sie
1. Remove in the order indicated in the table.
1 Brake pipe
2 Bolt
3

Dual proportioning valve

(See P–17 Dual Proportioning Valve Installation
Note)
2. Install in the reverse order of removal.
P–16
CONVENTIONAL BRAKE SYSTEM
A'
2,450 {25, 355} ± 200 {2, 29}
B
5,880 {60, 853} 3,480 {35.5, 505} ± 300 {3, 44}
A6E691243900W01
A6E6912W006
A6E6912W007
2
kPa {kgf/cm , psi}
B'
A6E691243900W02
A6E6912W035