Mazda 6 2002 Workshop Manual page 879

Hide thumbs Also See for 6 2002:

Table of Contents

6. Set the headlights 3 m {10 ft} from the wall.

7. While adjusting one headlight, mask the other.

8. Start the engine to charge the battery.

9. Turn on the lower-beam headlight.

10. Set the headlight leveling switch to 0 position.

11. Adjust the headlights by turning the adjusting

screws as shown in the figure. Loosen the screws

first, then tighten them.

• If the adjusting screws are tightened first,

then loosened, they will continue to loosen

when the vehicle is in motion and may cause

the headlights to become misaligned.

12. Turn the adjusting screws and adjust the

headlight so that the elbow point in the shaded

area in the figure.

1. Adjust the tire air pressure to the specification.

2. Position the unloaded vehicle on a flat, level surface.

3. Seat one person in the driver's seat.

4. Position the vehicle straight ahead and perpendicular to a wall.

EXTERIOR LIGHTING SYSTEM

Chapters

Table of Contents