Mazda 6 2002 Workshop Manual page 146

Monitor item
(Definition) Condition
SEGRP (EGR valve
(stepping motor)
position)
SHRTFT1 (Short term
fuel trim)
SPARKADV (Ignition
timing)
TEST (Test mode) ON/OFF
TP (TP)
TPCT
(TP sensor voltage at
CTP )
VPWR (Battery positive
voltage)
VSS (Vehicle speed) km/h MPH
VT DUTY1
1
* : Calculated value; differs from terminal voltage
2
* : Refrigerant pressure switch (middle) turns on when the refrigerant pressure is 1.69—1.84 MPa {17.3—18.7
kgf/cm2, 247—265 psi}
3
* : Refrigerant pressure switch (middle) turns off when the refrigerant pressure is 1.26—1.49 MPa {12.9—15.1
kgf/cm2, 184—214 psi}
4
* : L3 and L8, LF (Intensely hot area) models
5
* : Immobilizer system equipped
6
* : Immobilizer system not equipped
• Following PIDs are for the ATX models. If inspects for following PIDs, see
INSPECTION.
PIDs for the ATX models
— GEAR
— LINEDES
— LPS
— OP_SW_B
— SSA/SS1
— SSB/SS2
— SSC/SS3
— TCS
— TFT
— TFTV
— THOP
— TR
— TR_SENS
— TSS
End Of Sie
CONTROL SYSTEM
Unit/ Condition/Specification
(Reference)
Ignition switch ON: 0 step
STP Idle: 0 step
Cranking: 0—60 steps
Idle (after warm up): appro.–30—
%
25%
Ignition switch ON: BTDC 0°
BTC
Idle: BTDC appro. 10°
CTP: 13—23%
%
WOT: 86—96%
CTP: 0.65—1.15 V
V
WOT: 4.3—4.8 V
V 0.65—1.15 V
V Ignition switch ON: B+
Vehicle speed 20 km/h {12 mph}:
20 km/h {12 mph}
Vehicle speed 40 km/h {25 mph}:
20 km/h {12 mph}
ANGLE Idle: 0°
% Idle: 0%
Inspect following PIDs: MAF, TP,
ECT, RPM, VSS.
Inspect EGR valve.
(See F–40 EGR VALVE
INSPECTION)
Perform applicable DTC
troubleshooting.
(See F–67 DTC
Inspect following PIDs: MAF, TP,
ECT, RPM, INGEAR, TR, PSP,
ACSW, VPWR.
Inspect ignition timing.
(See F–8 IGNITION TIMING
INSPECTION)
—
Inspect TP sensor.
(See F–51 THROTTLE POSITION
(TP) SENSOR
Inspect TP sensor.
(See F–51 THROTTLE POSITION
(TP) SENSOR
Inspect main relay.
(See T–24 RELAY
Inspect battery.
(See G–4 BATTERY
Perform applicable DTC
troubleshooting.
(See F–67 DTC
Inspect following PIDs: TP, ECT,
RPM.
Inspect OCV.
(See B–33 OIL CONTROL VALVE
(OCV) INSPECTION)
Action
TABLE)
—
INSPECTION)
INSPECTION)
INSPECTION)
INSPECTION)
TABLE)
K–110 PID/DATA MONITOR
PCM
terminal
4E
4H
4K
4N
—
F
2J
2M
—
2A
2A
2Y, 2Z
—
2I, 2L
F–49