Base Installation - Mazda 6 2002 Workshop Manual

BASE INSTALLATION

1. Cut away all of the original sealant using a razor.
2. Clean and degrease the ceramic coating on the glass and the base.
3. Apply primer to the bonding area of the glass and the base.
Caution
• • • • Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly
bond to the surface of the glass.
4. Apply a height of 3.0 mm {0.12 in} sealant to the
base.
Note
• Use only glass primer on the glass, and
body primer on the base. Allow the primer to
dry for approimately 30 minutes.
5. Center the base in the ceramic coating and press
it onto the glass.
6. Use isopropyl alcohol to remove any ecess
repair sealant.
Hardening time of sealant
Temperature
hardening time
5 °C {41 °F} Appro. 1.5 h
20 °C {68 °F} Appro. 1 h
35 °C {95 °F} Appro. 10 min.
7. Install the rearview mirror.
End Of Sie
S–62
REARVIEW MIRROR
Time required
Surface until vehicle can
be put into
service
Appro. 12 h
Appro. 4 h
Appro. 2 h
A6E773469240W02
A6E7734W004
A6E7734W005