Wheel Hub, Hub Spindle Removal/Installation - Mazda 6 2002 Workshop Manual

WHEEL HUB, HUB SPINDLE REMOVAL/INSTALLATION

Caution
• • • • Performing the following procedures without first removing the ABS wheel-speed sensor may
possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the
following procedures, remove the ABS wheel-speed sensor (body side) and fi it to an appropriate
place where the sensor will not be pulled by mistake while the vehicle is being serviced.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
1 Hub cap
2 Locknut
(See M–10 Locknut Removal
(See M–11 Locknut Installation
3 Parking brake cable
4 Brake caliper component
5 Disc plate
(See P–20 Disc Plate Removal
6 Wheel hub component
Locknut Removal Note
1. Knock the crimped portion of the locknut outward
using a small cape chisel and a hammer.
2. Lock the hub by applying the brakes.
3. Remove the locknut.
M–10
REAR AXLE
.
Note)
Note)
Note)
7 Wheel hub
8 Hub bolt
(See M–7 Hub Bolt Removal
(See M–7 Hub Bolt Installation
9 ABS sensor rotor (with ABS)
(See M–11 ABS Sensor Rotor Removal
(See M–11 ABS Sensor Rotor Installation
10 Dust cover
11 Hub spindle
A6E631405000W02
A6E0312W078
Note)
Note)
Note)
Note)
A6E0312W021