Windshield Wiper Motor; Wiper And Washer - Mazda 6 2002 Workshop Manual

WINDSHIELD WIPER MOTOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the windshield wiper arm and blade. (See
INSTALLATION.)
3. Remove the cowl grille. (See
4. Remove in the order indicated in the table.
1 Connector
2 Bolt
3

Windshield wiper motor

5. Install in the reverse order of removal.
6. Adjust the windshield wiper arm and blade. (See
T–58 WINDSHIELD WIPER ARM AND BLADE
ADJUSTMENT.)
End Of Sie
WINDSHIELD WIPER MOTOR DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
1 Windshield wiper link (See
Link Removal Note)
2 Bolt
3 Windshield wiper motor
2. Assemble in the reverse order of disassembly.
Windshield Wiper Link Removal Note
1. Pry off the connection between the windshield wiper motor and windshield wiper link.
End Of Sie
WINDSHIELD WIPER MOTOR INSPECTION
L.H.D.
1. Disconnect the windshield wiper motor connector.
2. Connect battery positive voltage to terminal E or
D and ground to terminal B, and inspect the
operation of the windshield wiper motor as
indicated below.
Terminal
E
D
3. Disconnect battery positive voltage from terminal
E of the motor while the wipers are operating.
4. Verify that the wipers do not stop in the park
position.
5. Short between the motor terminals A and D and
connect battery positive voltage to the motor terminal C.
6. Verify that the wipers operate at low speed again, then stop in the park position.
• If not as specified, replace the windshield wiper motor.
T–56

WIPER AND WASHER

WIPER AND WASHER
T–57 WINDSHIELD WIPER ARM AND BLADE REMOVAL/
S–50 COWL GRILLE
T–56 Windshield Wiper
Operation
High
Low
REMOVAL/INSTALLATION.)
A6E811667340W01
A6E8116W102
A6E811667340W02
A6E8116W140
A6E811667340W03
A6E8116W127