WITHOUT OIL COOLER
.
1
Oil hose
(See
K40 Oil Pipe, Hose Clamp, Oil Hose
Installation
Note.)
2
Hose clamp
(See
K40 Oil Pipe, Hose Clamp, Oil Hose
Installation
Note.)
3
Connector bolt
Radiator (In Tank Oil Cooler) Installation Note
1. The automatic transale oil cooler flushing must be performed whenever a transale is removed for service
because the eisting fluid may be contaminated, and to prevent contamination of new fluid.
Note
• The flushing must be performed after installation of the overhauled or replacing transale.
2. Follow the instructions in the manufacturers publication for flushing operation.
Oil Pipe, Hose Clamp, Oil Hose Installation Note
1. Apply compressed air to cooler-side opening, and
blow any remaining grime and foreign material
from the cooler pipes. Compressed air should be
applied for no less than one minute.
K40
AUTOMATIC TRANSAXLE
4
O-ring
5
Radiator (in tank oil cooler)
(See
K40 Radiator (In Tank Oil Cooler) Installation
Note.)
A6E5614W080
A6E5614W070