Drive Shaft Installation Note
Caution
• • • • The sharp edges of the drive shaft can
slice or puncture the oil seal. Be careful
when installing the drive shaft to the
transale.
• • • • The oil seals are damaged easily if this
procedure is not done correctly.
1. Insert the drive shaft into the wheel hub.
2. Apply transale oil to the oil seal lip.
3. Push the drive shaft into the transale.
4. After installation, pull the transale side outer ring
forward to confirm that the drive shaft is securely
held by the clip.
End Of Sie
DRIVE SHAFT (ATX) DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
.
1
Boot band (wheel side)
(See
M20 Boot Band (Wheel Side) Disassembly
Note)
(See
M23 Boot Band (Wheel Side) Assembly
Note)
2
Boot band (transale side)
(See
M20 Boot Band (Transale Side)
Disassembly
Note)
(See
M23 Boot Band (Transale Side) Assembly
Note)
3
Outer ring
(See
M20 Outer Ring Disassembly
(See
M22 Outer Ring Assembly
4
Snap ring
(See
M20 Snap Ring, Tripod Joint Disassembly
Note)
(See
M22 Tripod Joint, Snap Ring Assembly
DRIVE SHAFT
5
6
7
8
Note)
Note)
9
10
Note)
Tripod joint
(See
M20 Snap Ring, Tripod Joint Disassembly
Note)
(See
M22 Tripod Joint, Snap Ring Assembly
Free ring
Boot
(See
M21 Boot Disassembly
(See
M22 Boot Assembly
Note)
ABS sensor rotor (with ABS)
(See
M21 ABS Sensor Rotor (With ABS)
Disassembly
Note)
(See
M22 ABS Sensor Rotor (With ABS) Assembly
Note)
Shaft and ball joint component
Dynamic damper
(See
M21 Dynamic Damper Assembly
A6E6316W003
A6E631625500W03
M
A6E0313W043
Note)
Note)
Note)
M19