ON-BOARD DIAGNOSTIC (DYNAMIC STABILITY CONTROL)
STEP
8
INSPECT DSC HU/CM OPERATION
• Perform DSC HU/CM system inspection.
• See
P35 DSC SYSTEM INSPECTION
• Is it okay?
9
VERIFY TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear DTC from memory.
(See
P46 Clearing DTCs
• Start engine and drive vehicle at 10 km/h
{6.2 mph} or above.
• Gradually slow down vehicle and stop.
• Is same DTC present?
10
VERIFY AFTER REPAIR PROCEDURE
• Is there any other DTC present?
DTC C1186, C1266
End Of Sie
Caution
• • • • When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used.
DTC
C1186, C1266
• C1186:
Fail-safe relay in DSC HU/CM stuck OFF when ignition switch is turned ON, fail-safe relay ON is
DETECTION
CONDITION
• C1266:
Fail-safe relay in DSC HU/CM stuck ON when ignition switch is turned ON, fail-safe relay OFF is
• Malfunction of fuse (ABS 60 A)
POSSIBLE
• Open circuit in harness between DSC HU/CM terminal C and battery positive terminal
CAUSE
• Open or short of fail-safe relay in DSC HU/CM
• Stuck fail-safe relay in DSC HU/CM
P86
INSPECTION
Procedures)
Fail-safe relay
commanded.
commanded.
Yes Go to net step.
No
Replace DSC HU/CM, then go to net step.
Yes Replace DSC HU/CM, then go to net step.
No
Go to net step.
Yes Go to applicable DTC inspection.
No
Troubleshooting completed.
ACTION
A6E697367650W14