3
Reservoir
4
Joint bushing
5
Snap ring
6
Piston guide
7
Cup
8
Stopper
9
Primary piston
Stop Screw and O-ring (without ABS) Assembly Note
1. Install the secondary piston and primary piston.
2. Install the new O-ring onto the stop screw.
3. Push the primary piston assembly in full.
4. Install and tighten the stop screw.
Tightening torque
2.02.4 N·m {2124 kgf·cm, 1821 in·lbf}
5. Push and release the secondary piston
component to verify that it is held properly by the
stop screw.
Stop Pin and O-ring (with ABS) Assembly Note
1. Install the secondary piston with the piston hole facing the stop pin and primary piston.
2. Install the new O-ring onto the stop pin.
3. Push the primary piston assembly in full.
4. Install and tighten the stop pin.
Tightening torque
6.99.8 N·m {7199 kgf·cm, 6286 in·lbf}
5. Push and release the secondary piston
component to verify that it is held properly by the
stop pin.
End Of Sie
CONVENTIONAL BRAKE SYSTEM
10
Stop pin and O-ring (with ABS)
(See
P13 Stop Pin and O-ring (with ABS)
Assembly
Note)
11
Stop screw and O-ring (without ABS)
(SeeP13 Stop Screw and O-ring (without ABS)
Assembly
Note)
12
Secondary piston
13
Master cylinder body
P
A6E6912W025
A6E6912W043
P13