Mazda 6 2002 Workshop Manual page 912

WASHER FLUID-LEVEL SENSOR INSPECTION
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See
3. Insoect for continuity between the washer fluid-
level sensor terminals using an ohmmeter.
4. Verify that the windshield washer motor operates.
• If not as specified, replace the washer fluid-
level sensor.
End Of Sie
WINDSHIELD WASHER NOZZLE REMOVAL/INSTALLATION
1. Remove the bonnet insulator.
2. Remove the windshield washer hose from the windshield washer nozzle.
3. Compress the hooks of the windshield washer nozzle.
4. Pull the windshield washer nozzle out to remove
it.
5. Install in the reverse order of removal.
End Of Sie
WINDSHIELD WASHER NOZZLE CLEANING
1. Clean the washer nozzle by inserting and moving
a needle or an equivalent tool back and forth.
• If the nozzle becomes clogged again after
cleaning, remove the hose from washer
nozzle. Make sure there is enough washer
fluid. Then turn the washer switch on and
flush the inside of the hose.
End Of Sie
T–60
WIPER AND WASHER
T–58 WASHER TANK REMOVAL/INSTALLATION)
A6E8116W144
A6E811676670W04
A6E8116W130
A6E811667510W01
A6E8116W143
A6E811667510W03
A6E8116W124