Mazda 6 2002 Workshop Manual page 49

29. Hold the ehaust camshaft using a suitable
wrench on the cast heagon as shown.
30. Tighten the ehaust camshaft sprocket lock bolt.
Tightening torque:
69—75 N·m {7.10—7.6 kgf·m, 50.9—55.3 ft·lbf}
31. Remove the SST from the camshaft.
32. Remove the SST from the block lower blind plug.
33. Rotate the crankshaft clockwise two turns until
the TDC position.
• If not aligned, loosen the crankshaft pulley
lock bolt and repeat from Step 14.
34. Apply silicone sealant to the engine front cover
upper blind plug.
35. Install the engine front cover upper blind plug.
Tightening torque:
10 N·m {1.0 kgf·m, 7.4 ft·lbf}
36. Install the cylinder block lower blind plug.
Tightening torque:
18—22 N·m {1.9—2.2 kgf·m, 13.3—16.2 ft·lbf}
37. Install the new engine front cover lower blind
plug.
Tightening torque:
12 N·m {1.2 kgf·m, 8.9 ft·lbf}
38. Connect the front drive shaft (RH) and the joint
shaft. (See M–17 DRIVE SHAFT REMOVAL/
INSTALLATION)
39. Install the drive belt. (See
REPLACEMENT.)
40. Install the cylinder head cover. (See
Cylinder Head Cover Installation
41. Install the ventilation hose.
42. Install the oil control valve (OCV) connector.
43. Install the high-tension lead. (See
44. Install the spark plugs. (See
45. Install the splash shield (RH).
46. Install the tire (RH).
End Of Sie
B–8
VALVE CLEARANCE
B–3 DRIVE BELT
B–17
Note.)
G–11 HIGH-TENSION LEAD
G–10 SPARK PLUG
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
AME2212W006
AME2212W003
AME2212W012
AME2212W002