STARTER INSPECTION
On-vehicle Inspection
1. Verify that the battery is fully charged.
2. Crank the engine and verify that the starter rotates smoothly without any noise.
• If not, inspect the following.
Remove the starter and inspect the magnetic switch and the starter.
Inspect the related wiring harness and the ignition switch.
No Load Test
1. Verify that the battery is fully charged.
2. Connect the starter, battery, voltmeter and
ammeter as shown.
3. Operate the starter and verify that it rotates
smoothly.
4. Measure the voltage and current while the starter
is operating.
• If not as specified, replace the starter.
Specification
Voltage (V)
11
End Of Sie
STARTING SYSTEM
Current (A)
Less than 90
A6E471418400W02
AME4714W002
G13