DSC HU/CM REMOVAL/INSTALLATION
Caution
• • • • When replacing the DSC HU/CM, configuration procedure must be done before removing the DSC
HU/CM. If configuration is not completed before removing the DSC HU/CM, DTC B2477 will be
detected.
• • • • Do not drop the DSC HU/CM. Replace it if it is subjected to an impact.
1. Configurate the DSC HU/CM (when only replacing it).(See
CONFIGURATION.)
2. Remove the battery, battery tray and battery tray bracket.(See
3. Remove the under cover.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
.
1
Connector
(See
P39 Connector Removal
(See
P39 Connector Installation
2
Brake pipe
P38
DYNAMIC STABILITY CONTROL
Note)
Note)
P29 ABS (ABS/TCS) or DSC HU/CM
G3 BATTERY
REMOVAL/INSTALLATION.)
3
DSC HU/CM and Bracket
(See
P39 DSC HU/CM and Bracket Removal/
Installation
Note)
4
Bracket
5
DSC HU/CM
A6E692067650W03
A6E6920W001