16. Install the splash shield (RH).
17. Install the tire (RH).
End Of Sie
VALVE CLEARANCE ADJUSTMENT
1. Disconnect the negative battery cable.
2. Remove the tire (RH).
3. Remove the splash shield (RH).
4. Remove the spark plugs. (See
5. Remove the high-tension lead.
6. Remove the oil control valve (OCV) connector.
7. Remove the ventilation hose.
8. Remove the cylinder head cover.
9. Remove the drive belt. (See
10. Remove the joint shaft from the front drive shaft (RH). (See
11. Remove the engine front cover lower blind plug.
12. Remove the engine front cover upper blind plug.
13. Remove the cylinder block lower blind plug.
14. Install the SST as shown.
15. Turn the crankshaft clockwise the crankshaft is in
the No.1 cylinder TDC position.
VALVE CLEARANCE
G10 SPARK PLUG
REMOVAL/INSTALLATION.)
B3 DRIVE BELT
REPLACEMENT.)
M17 DRIVE SHAFT
REMOVAL/INSTALLATION.)
A6E221212111W02
B
AME2212W002
AME2212W003
AME2212W004
B5