SIDE PROTECTOR INSTALLATION
1. Remove the adhesive remaining on the side protector (if it will be reused) and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and the body.
3. Attach double-sided adhesive tape to the side
protector as shown (if it will be reused).
Clearance
a: 30.0 mm {1.18 in}
b: 3.0 mm {0.11 in}
c: 12.0 mm {0.47 in}
d: 3.0 mm {0.11 in}
e: 3.0 mm {0.11 in}
f: 1.03.0 mm {0.040.11 in}
g: 5.0 mm {0.19 in}
h: 2.0 mm {0.07 in}
4. Peel off the backing paper from the double-sided
adhesive tape and attach the side protector onto
the body as shown.
Clearance
a: 1.24.2 mm {0.050.16 in}
b: 3.26.2 mm {0.130.24 in}
End Of Sie
EXTRACTOR CHAMBER REMOVAL/INSTALLATION
1. Remove the rear bumper. (See
2. Remove the left side trunk side trim.
3. Remove the screw.
4. Squeeze the clips with your fingers and remove
the etractor chamber from the vehicle side.
5. Install in the reverse order of removal.
End Of Sie
EXTERIOR ATTACHMENT
S49 REAR BUMPER
REMOVAL/INSTALLATION.)
A6E772850680W02
A6E7728W007
S
A6E7728W008
A6E772851920W01
A6E7728W001
S53