Dtc P0550 - Mazda 6 2002 Workshop Manual

DTC P0550

DTC P0550 PSP switch circuit malfunction
• PCM monitors PSP switch signal at PCM terminal 1Z. If input voltage is low (switch stays on) for 1 minute
when VSS is above 60 km/h {37.3 mph} and ECT is above 60 ° ° ° ° C {140 ° ° ° ° F}, PCM determines that PSP
switch circuit has malfunction.
Diagnostic support note
DETECTION
• This is a continuous monitor (CCM).
CONDITION
• MIL illuminates if PCM detects the above malfunction conditions in two consecutive drive cycles or in one
drive cycle while the DTC for the same malfunction has been stored in the PCM.
• PENDING CODE is available if PCM detects the above malfunction condition during first drive cycle.
• FREEZE FRAME DATA is available.
• DTC is stored in PCM memory.
• PSP switch malfunction
• Connector or terminal malfunction
POSSIBLE
• Short to ground in wiring between PSP switch terminal and PCM terminal 1Z
CAUSE
• Open circuit in wiring between PSP switch terminal and PCM terminal 1Z
• PCM malfunction
Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has FREEZE FRAME DATA been recorded?
2 VERIFY RELATED SERVICE INFORMATION
AVAILABILITY
• Check for related Service Information
availability.
• Is any related Service Information available?
3 INSPECT POOR CONNECTION OF PSP
CONNECTOR
• Turn ignition key to OFF.
• Disconnect PSP connector.
• Inspect for poor connection (damaged, pulled-
out terminals, corrosion, etc.).
• Are there any malfunctions?
F–150
ON-BOARD DIAGNOSTIC
INSPECTION
Yes Go to net step.
No Record FREEZE FRAME DATA on repair order, then go to
net step.
Yes Perform repair or diagnosis according to available Service
Information.
• If vehicle is not repaired, go to net step.
No Go to net step.
Yes Repair or replace terminal, then go to Step 8.
No Go to net step.
A6E397001087W06
ACTION