Mazda 6 2002 Workshop Manual page 887

REAR COMBINATION LIGHT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the trunk side trim. (See
3. Remove in the order indicated in the table.
1 Connector
2 Bolt
3 Rear combination light
4 Socket
5 Rear turn light bulb
6 Brake light/taillight bulb
4. Install in the reverse order of removal.
End Of Sie
INBOARD COMBINATION LIGHT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the trunk lid trim (liftgate lower trim). (See
S–95 LIFTGATE LOWER TRIM
3. Remove in the order indicated in the table.
1 Connector
2 Nut
3 Inboard combination light (See
Combination Light Installation
4 Socket
5 Back-up light bulb
6 Rear fog light bulb (L.H.D.: left side only, R.H.D.:
right side only)
4. Install in the reverse order of removal.
Inboard Combination Light Installation Note
1. Insert the inboard combination light into the trunk
lid (liftgate) as shown in the figure, then pivot it
inward and fi in place.
EXTERIOR LIGHTING SYSTEM
S–92 TRUNK SIDE TRIM
S–93 TRUNK LID TRIM
REMOVAL/INSTALLATION)
T–35 Inboard
Note)
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION) (See
A6E811251150W01
A6E8112W118
A6E811251380W01
T
A6E8112W119
A6E8112W120
T–35