PARKING BRAKE (LEVER TYPE) INSPECTION
1. Pull the parking brake lever a few times.
2. Depress the brake pedal a few times.
3. Inspect the parking brake stroke by pulling the parking brake lever with a force of 98 N {10 kgf, 22 lbf}.
Stroke
36 notches
End Of Sie
PARKING BRAKE (LEVER TYPE) ADJUSTMENT
1. Start the engine and depress the brake pedal several times.
2. Stop the engine.
3. Remove the ashtray behind the center console.
4. Turn the adjusting nut as shown in the figure.
5. After adjustment, inspect the following points:
(1) Turn the ignition switch to ON, pull the parking
brake lever one notch, and verify that the
parking brake warning light illuminates.
(2) Verify that the rear brakes do not drag.
End Of Sie
PARKING BRAKE (LEVER TYPE) REMOVAL/INSTALLATION
1. Remove the center console. (See
2. Remove the rear seat cushion (4SD) or rear seat (5HB) . (See
INSTALLATION.)
3. Remove the ehaust pipe bracket.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the parking brake stroke. (See
.
1
Parking brake switch
2
Adjusting nut
3
Parking brake lever
End Of Sie
P26
PARKING BRAKE SYSTEM
PARKING BRAKE SYSTEM
S86 CONSOLE
REMOVAL/INSTALLATION.)
P26 PARKING BRAKE (LEVER TYPE)
S110 REAR SEAT REMOVAL/
ADJUSTMENT.)
4
Clip
5
Parking brake cable
A6E691444000W01
A6E691444000W02
A6E6914W002
A6E691444000W03
A6E6914W001