Mazda 6 2002 Workshop Manual page 423

Hide thumbs Also See for 6 2002:

Table of Contents

AUTOMATIC TRANSAXLE SHIFT MECHANISM

• • • • Bending the selector cable in the manner

shown in the figure will damage the cable

and it may become loose when shifted.

When installing the selector cable, hold it

• Install the selector lever to the manual shaft

lever with the spring side of the selector

cable end facing the front of the vehicle.

6. Install the selector lever to the manual shaft lever

in such a way that the selector cable does not bear a load.

7. Confirm that the end of the manual shift lever sticks out of the end of the selector cable.

8. Install the selector cable to the selector cable securely bracket.

Interlock Cable Installation Note

1. Verify that the shift the selector lever in P position and ignition key is in LOCK position.

2. Press the lock unit onto the brake pedal stopper bracket.

3. From this position, slide the lock unit to fi the

lock unit hook into the bracket hole securely as

shown in the figure.

• • • • Allowing the interlock cable to be bent or

twisted during installation can affect the

lock unit operation.

4. Install the interlock cable end onto the cam pin on

the selector lever.

5. Fit the interlock cable in the U–groove in the

selector lever base plate, and install the clip.

• • • • Applying a load to the interlock cable

while pressing the lock piece in can

affect the lock unit operation.

Chapters

Table of Contents