Pre-Delivery Inspection - Mazda 6 2002 Workshop Manual

PRE-DELIVERY INSPECTION

PRE-DELIVERY INSPECTION TABLE
EXTERIOR
• INSPECT and ADJUST, if necessary, the
following items to specification:
❏Glass, eterior bright metal and paint for damage
❏All weatherstrips for damage or detachment
❏Door operation and alignment including side door
and back door
❏Wheel lug nuts
❏Tire pressures
❏Headlight aiming
❏Headlight cleaner and fluid level (if equipped)
❏Operation of bonnet release and lock
❏Operation of liftgate and fuel lid opener
• INSTALL the following parts:
❏Flap (front and rear)
❏Wheel caps or rings (if equipped)
UNDER BONNET—ENGINE OFF
• INSPECT and ADJUST, if necessary, the
following items to specification:
❏Fuel, engine coolant, and hydraulic lines, fittings,
connections, and components for leaks
❏Accelerator cable and linkage for free movement
❏Tension of drive belts
❏Tightness of water hose clamps
❏Tightness of battery terminals, electrolyte level and
specific gravity
❏Radiator coolant level and specific gravity
❏Engine oil level
❏Oil level in steering gearbo
❏Windshield washer tank fluid level
❏Brake master cylinder fluid level
❏Clutch master cylinder fluid level (MTX only)
❏Power steering fluid level
❏Manual transale oil level (MTX only)
CLEAN the spark plugs
INTERIOR
• INSTALL the following parts:
❏Fuse for accessories
• CHECK the operations of the following items:
❏All lights including warning, and indicator lights
❏Cigarette lighter and clock
❏Ignition switch and steering lock
❏Transale range switch (ATX only)
❏Warning buzzers
❏Seat belts warning system
❏Ignition key reminder alarm
❏Seat controls (sliding and reclining) and headrests
GI–32
PRE-DELIVERY INSPECTION
PRE-DELIVERY INSPECTION
A6E203200012W01
❏Seat belt warning system
❏Door locks, including childproof door locks
❏Power door lock
❏Power windows (if equipped)
❏Horn, wipers, and washers
❏Wiper blades performance
Clean the wiper blades and windshield, if necessary
❏Antenna
• CHECK the following items:
❏Presence of spare fuse
❏Upholstery and interior finish
• CHECK and ADJUST, if necessary, the following
items:
❏Operation and fit of windows
❏Parking brake
❏Pedal height and free play of brake pedal
UNDER BONNET—ENGINE RUNNING AT
OPERATING TEMPERATURE
• CHECK the following items:
❏Operation of idle-up system for electrical load, air
conditioner
❏Idle speed
❏Automatic transale fluid level (ATX only)
❏Initial ignition timing
❏Operation of throttle position sensor
❏Operation of EGR valve
ON HOIST
• CHECK the following items:
❏Underside fuel, coolant and hydraulic lines, fittings,
connections, and components for leaks
❏Tires for cuts or bruises
❏Steering linkage, suspension, ehaust system, and
all underside hardware for looseness or damage
ROAD TEST
• CHECK the following items:
❏Brake operation
❏Clutch operation
❏Steering control
❏Operation of meters and gauges, squeaks, rattles,
and abnormal noises
❏Engine general performance
❏Emergency locking retractors
AFTER ROAD TEST
• REMOVE the seat and floor mat protective covers
CHECK for the necessary owner information
materials, tools, and spare tire in vehicle
End Of Sie