Mazda 6 2002 Workshop Manual page 433

DTC P0707 Transale range (TR) switch circuit low input
Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has FREEZE FRAME PID DATA been
recorded?
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Bulletins availability.
• Is any related repair information available?
3 INSPECT TR SWITCH CONNECTOR
• Turn ignition key OFF.
• Disconnect TR switch connector.
• Inspect for bent terminals of TR switch
terminals B and C (part-side).
• Are TR switch terminals okay?
4 INSPECT TR SWITCH
• Turn ignition key to OFF.
• Disconnect TR switch connector.
• Inspect for resistance between TR switch
terminals B and C (part-side).
• Is resistance okay?
(See K–14 TRANSAXLE RANGE (TR) SWITCH
INSPECTION.)
ON-BOARD DIAGNOSTIC
INSPECTION
Yes Go to net step.
No Record FREEZE FRAME PID DATA on repair order, then
go to net step.
Yes Perform repair or diagnosis according to available repair
information.
• If vehicle is not repaired, go to net step.
No Go to net step.
Yes Go to net step.
No Repair terminals or replace TR switch, then go to Step 7.
(See K–15 TRANSAXLE RANGE (TR) SWITCH
REMOVAL/INSTALLATION.)
Yes Go to net step.
No Adjust TR switch, then go to Step 7.
(See K–18 TRANSAXLE RANGE (TR) SWITCH
ADJUSTMENT.)
ACTION
K–59
K