Mazda 6 2002 Workshop Manual page 878

FRONT COMBINATION LIGHT REMOVAL/INSTALLATION
Caution
• • • • Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing
the discharge headlights, always refer to the “Discharge headlight service warnings.” (See
DISCHARGE HEADLIGHT SERVICE
Note
• When the ignition switch is turned to ON, it is normal to hear the headlight leveling actuator operating for a
few second, as it verifies headlight auto leveling system operating condition.
1. Disconnect the negative battery cable.
2. Remove the front bumper. (See
3. Remove in the order indicated in the table.
1 Connector
2 Bolt
3 Clip
4 Cover
5 Front combination light
4. Install in the reverse order of removal.
5. Adjust the headlight aiming. (See
HEADLIGHT AIMING.)
End Of Sie
HEADLIGHT AIMING
Low-beam
1. Set up a screen as shown in the figure below for
aiming the headlights.
2. Adjust the tire air pressure to the specification.
3. Position the unloaded vehicle on a flat, level
surface.
4. Seat one person in the driver's seat.
5. Position the vehicle straight ahead and
perpendicular to a wall.
T–26
EXTERIOR LIGHTING SYSTEM
WARNINGS)
S–47 FRONT BUMPER
T–26
REMOVAL/INSTALLATION)
A6E811251060W02
T–25
A6E8112W101
A6E811251030W01
A6E8112W132
A6E8112W133