Mazda 6 2002 Workshop Manual page 891

STEERING ANGLE SENSOR INSPECTION
With DSC
1. Remove the column cover. (See
2. Disconnect the steering angle sensor connector.
3. Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor.
4. Turn the steering wheel to the right and left, and
verify that the voltage and pulses at the terminals
are as shown in the figure.
• If not as specified, replace the body of the
combination switch.
End Of Sie
LIGHT SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the column cover. (See
3. Remove in the order indicated in the table.
1 Connector
2 Screw
3 Light switch
4. Install in the reverse order of removal.
End Of Sie
EXTERIOR LIGHTING SYSTEM
S–84 COLUMN COVER
S–84 COLUMN COVER
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION)
A6E811266120W03
A6E8112W143
T
A6E811266121W01
A6E8112W112
T–39