Mazda 6 2002 Workshop Manual page 471

DTC P0763 Shift solenoid C malfunction (electrical)
Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has FREEZE FRAME PID DATA been
recorded?
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Bulletins availability.
• Is any related repair information available?
3 INSPECT ATX CONNECTOR FOR POOR
CONNECTION
• Turn ignition key to OFF.
• Disconnect ATX connector.
• Check for poor connection (damaged/pulled-
out terminals, corrosion, etc.).
• Is connection okay?
4 INSPECT RESISTANCE
• Inspect resistance between ATX connector
terminal G (transale case side) and body
ground.
• Is resistance within 1.0—4.2 ohms?
(See K–26 Resistance Inspection (On-Vehicle
Inspection).)
ON-BOARD DIAGNOSTIC
INSPECTION
Yes Go to net step.
No Record FREEZE FRAME PID DATA on repair order, then
go to net step.
Yes Perform repair or diagnosis according to available repair
information.
• If vehicle is not repaired, go to net step.
No Go to net step.
Yes Go to net step.
No Repair or replace connector and/or terminals, then go to
Step 11.
Yes Go to Step 7.
No Go to net step.
ACTION
K–97
K