Mazda 6 2002 Workshop Manual page 874

Hide thumbs Also See for 6 2002:

Table of Contents

Socket Removal Note

1. Insert a tape-wrapped screwdriver into the socket

hole, then press against the ring protrusion to lift

the socket toward you.

2. As shown in the figure, lift out the socket until the

ring protrusion locks into the lower socket hole.

3. Remove the boot panel.

4. From behind the boot panel, slide a tape-wrapped

screwdriver in between the socket and the ring

protrusion..

5. While twisting the ring protrusion with the

screwdriver, push out and remove the socket.

Ring Removal Note

1. Pull the ring forward while compressing the

CIGARETTE LIGHTER INSPECTION

1. Turn the ignition switch to ACC position.

2. Verify that the cigarette lighter comes out within 10—20 seconds, after pressing the plug into the socket.

• If the cigarette lighter does not operate normally, replace the cigarette lighter plug and socket.

POWER SYSTEM

A6E811067000W02

Chapters

Table of Contents