Mazda 6 2002 Workshop Manual page 565

Brake Pedal Play Inspection
1. Depress the pedal a few times to eliminate the vacuum in the system.
2. Remove the spring pin, verify that the holes in the fork and in the pedal are aligned, and reinstall the pin. (See
P–9 BRAKE PEDAL
3. Gently depress the pedal by hand until resistance is felt, and check the pedal play.
Pedal play
0—3 mm {0—0.1 in}
Brake Pedal Play Adjustment
1. Remove the spring pin and clevis pin. (See
2. Loosen locknut D and turn rod C to align the
holes in the fork and in the pedal.
3. Install the clevis pin and the spring pin.
4. Tighten locknut D.
Tightening torque
15.7—21.6 N·m
{1.61—2.20 kgf·m, 11.6—15.9 ft·lbf}
5. Check the pedal height and the brake light
operation.
Pedal-to-floor Clearance Inspection
1. Start the engine and depress the brake pedal with
a force of 588 N {60 kgf, 132 lbf}
2. Verify that the distance from the floor panel to the
pedal pad center is as specified when the pedal is
depressed.
• If the distance is less than specified, check for
the air in brake system.
Specification
68 mm {2.7 in} min.
End Of Sie
BRAKE SWITCH INSPECTION
1. Disconnect the negative battery cable.
2. Disconnect the brake switch connector harness.
3. Inspect for continuity between the brake switch connector terminals.
• If not as specified, replace the brake switch.
End Of Sie
P–8
CONVENTIONAL BRAKE SYSTEM
REMOVAL/INSTALLATION.)
P–9 BRAKE PEDAL
A6E6912W033
REMOVAL/INSTALLATION.)
A6E6912W027
A6E6912W003
A6E691266490W01
A6E6912W034