Mazda 6 2002 Workshop Manual page 518

1 Tie-rod end ball joint
(See N–11 Tie-rod End Ball Joint Removal
2 bolt
3 Lower arm (front, rear) ball joint
(See R–15 FRONT LOWER ARM (FRONT)
REMOVAL/INSTALLATION)
(See R–19 FRONT LOWER ARM (REAR)
REMOVAL/INSTALLATION)
4 Stabilizer control link
5 Brake caliper component
(See M–13 Brake Caliper Component Removal
Note)
Brake Caliper Component Removal Note
1. Suspend the caliper aside with wire.
Wheel Hub, Steering Knuckle and Drive Shaft Removal Note
Caution
• • • • The sharp edges of the joint shaft can slice or puncture the oil seal. Be careful when removing the
joint shaft from the transale.
1. Pull the joint shaft straight out.
2. Install the SST into the transale to hold the side
gears after the joint shaft is removed.
DRIVE SHAFT
6 Disk plate
Note) (See
7 Wheel hub, steering knuckle and drive shaft
(See
Shaft Removal
8 Joint shaft bracket bolt
9 Joint shaft
10 Clip
(See
P–20 Disc Plate Removal Note)
M–13 Wheel Hub, Steering Knuckle and Drive
Note)
M–14 Clip Installation Note)
M
A6E0313W056
A6E0313W019
M–13