Rear Window Glass Installation - Mazda 6 2002 Workshop Manual

Hide thumbs Also See for 6 2002:

Table of Contents

4. Working with another person, saw through the

sealant around the edge of the glass.

5. Remove the rear window glass.

6. Remove the pins from the glass.

7. Remove the rear window molding from the glass.

REAR WINDOW GLASS INSTALLATION

• • • • To prevent the sealant from cracking or the glass from being pushed out by air pressure if a door

is closed, open all of the windows and leave them open until the sealant has hardened.

1. Cut away the old sealant using a razor so that 1—2 mm {0.04—0.07 in} thickness of sealant remains around

the circumference of the frame.

• • • • Using a razor with bare hands can cause injury. Always wear gloves when using a razor.

2. If the sealant has come off completely in any one place, apply some primer after degreasing, and allow it

approimately 30 minutes to dry. Then put on new sealant to create a 2 mm {0.08 in} layer.

3. Clean and degrease an approimately 50.0 mm {1.97 in} wide strip around the circumference of the glass

and the bonding area on the body.

4. Install the molding as shown in the figure.

WINDOW GLASS

A6E773863931W02

Table of Contents