Rear Lower Arm - Mazda 6 2002 Workshop Manual

Bound Stopper (Body Side) Removal/Installation Note
1. Remove or/and install the bound stopper (body side) using the etension bar.
Rear Coil Spring Installation Note
1. Install the coil spring so that the distinguisher
mark is located on under side.
2. Position the jack under the lower arm and jack up
slowly.
Warning
• • • • Installing the coil spring is dangerous.
The coil spring could fly off, and cause
serious injure of death.
3. Install the lower arm (outer side) bolt.
End Of Sie
REAR LOWER ARM REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the rear wheel alignment.
(See R–6 REAR WHEEL
1 Rear coil spring component
(See R–29 REAR COIL SPRING REMOVAL/
INSTALLATION)
2 Bolt (rear lower arm inner side)
3

Rear lower arm

End Of Sie
R–30
REAR SUSPENSION
ALIGNMENT.)
A6E7416W015
A6E741628310W01
A6E7416W008