CLOCK SPRING REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See
INSTALLATION.)
3. Remove the steering wheel. (See
4. Remove the column cover.
5. Remove in the order indicated in the table.
1
Screw
2
Connector
3
Clock spring
(See
T125 Clock Spring Installation
6. Install in the reverse order of removal.
7. Verify that the air bag system warning light
illuminates for approimately 6 seconds and
then goes off.
• If the air bag system warning light does not
operate in the manner described above, there
are malfunctions in the system. Inspect the
system using the on-board diagnostic.
Clock Spring Installation Note
Caution
• • • • If the clock spring is not adjusted, the spring wire in the clock spring will break due to overtension
when the steering wheel is turned. Always adjust the clock spring after installing it.
• Adjust the clock spring after installing it. (See
End Of Sie
CLOCK SPRING ADJUSTMENT
Note
• The adjustment procedure is also specified on the caution label of the clock spring.
1. Set the front wheels straight ahead.
Caution
• • • • The clock spring will break if
over-wound. Do not forcibly turn the
clock spring.
2. Turn the clock spring clockwise until it stops.
3. Turn the clock spring counterclockwise 2 3/4
turns.
AIR BAG SYSTEM
T120 DRIVER-SIDE AIR BAG MODULE REMOVAL/
N7 STEERING WHEEL AND COLUMN
Note)
T125 CLOCK SPRING
REMOVAL/INSTALLATION.)
ADJUSTMENT.)
A6E813066123W01
A6E8130W008
A6E813066123W02
T
A6E8130W046
A6E8130W047
T125