Access Control Lists (Acls) - Dell S6100 Configuration Manual

This chapter describes access control lists (ACLs), prefix lists, and route-maps.
At their simplest, access control lists (ACLs), prefix lists, and route-maps permit or deny traffic based on MAC and/or IP addresses. This
chapter describes implementing IP ACLs, IP prefix lists and route-maps. For MAC ACLS, refer to
An ACL is essentially a filter containing some criteria to match (examine IP, transmission control protocol [TCP], or user datagram protocol
[UDP] packets) and an action to take (permit or deny). ACLs are processed in sequence so that if a packet does not match the criterion in
the first filter, the second filter (if configured) is applied. When a packet matches a filter, the switch drops or forwards the packet based on
the filter's specified action. If the packet does not match any of the filters in the ACL, the packet is dropped (implicit deny).
The number of ACLs supported on a system depends on your content addressable memory (CAM) size. For more information, refer to
Configurable CAM Allocation and
(CAM).
You can configure ACLs on VRF instances. In addition to the existing qualifying parameters, Layer 3 ACLs also incorporate VRF ID as one of
the parameters. Using this new capability, you can also configure VRF based ACLs on interfaces.
NOTE: You can apply Layer 3 VRF-aware ACLs only at the ingress level.
You can apply VRF-aware ACLs on:
• VRF Instances
• Interfaces
In order to configure VRF-aware ACLs on VRF instances, you must carve out a separate CAM region. You can use the cam-acl command
for allocating CAM regions. As part of the enhancements to support VRF-aware ACLs, the cam-acl command now includes the following
new parameter that enables you to allocate a CAM region: vrfv4acl.
The order of priority for configuring user-defined ACL CAM regions is as follows:
• V4 ACL CAM
• VRF V4 ACL CAM
• L2 ACL CAM
With the inclusion of VRF based ACLs, the order of precedence of Layer 3 ACL rules is as follows:
• Port/VLAN based PERMIT/DENY Rules
• Port/VLAN based IMPLICIT DENY Rules
• VRF based PERMIT/DENY Rules
• VRF based IMPLICIT DENY Rules
NOTE: In order for the VRF ACLs to take effect, ACLs configured in the Layer 3 CAM region must have an implicit-permit
option.
You can use the ip access-group command to configure VRF-aware ACLs on interfaces. Using the ip access-group command, in
addition to a range of VLANs, you can also specify a range of VRFs as input for configuring ACLs on interfaces. The VRF range is from 1 to
63. These ACLs use the existing V4 ACL CAM region to populate the entries in the hardware and do not require you to carve out a separate
CAM region.
NOTE: You can configure VRF-aware ACLs on interfaces either using a range of VLANs or a range of VRFs but not both.

Access Control Lists (ACLs)

CAM Optimization. For complete CAM profiling information, refer to
Layer 2.
Content Addressable Memory
Access Control Lists (ACLs)
6
User
107