Initial Installation - Mitel Panther II 820 System Manual

Mite1 Standard Practise
Initial Installation
(FOR PREVIOUSLY INSTALLED SYSTEMS, GO TO THE NEXT SECTION)
The
following instructions detail initial installation of the Feature Module IV Cartridge.
CAUTION: Don' t plug in the KSU power cord until you' re instructed to do so.
Step 1
Step
2
Step
3
Step 4
Step 5
Step
6
Step 7
Step
8
Mount the KSU as per the instructions in the INSTALLATION AND COM-
MISSIOZ-XNG PRACTICE of the PANTHER II SYSTEM
MANUAL.
There are two small grooves on the Feature Module IV Cartridge connector.
Holding the Feature Module IV Cartridge so that the grooves are facing you,
plug it securely into the port on the KSU (refer CO
the close-up shown in Fig-
ure 2-l).
Place the protective cover over the Feature Module IV Cartridge,
push in the plastic expansion plugs, and tighten the two screws.
Install the remainder of the system as outlined in the INSTALLATION AND
COMMISSIONING PRACTICE OF THE PANTHER II SYSTEM MAN-
UAL. After the system is completely installed, including the stations, plug in
the KSU power cord. Ensure the STATUS lamp on the side panel of the KSU
is flashing.
Set the MEM. CLEAR Switch to the ON position. The MEM. CLEAR Switch
(dipswitch #2) is located on the right-hand side panel of the KSU.
Press the RESET Switch.
Set the MEM. CLEAR Switch to the OFF position. The system is now reset to
the default settings.
Set the Battery Switch for the KSU memory to the ON position. The Battery
Switch (dipswitch #4) is located on the right-hand side panel of the KSU.
You must now program the system. Refer to the PROGRAMMING PRAC-
TICE in the PANTHER II SYSTEM MANUAL for instructions. You' ll find
programming instructions for the additional features provided by Feature
Module IV software and the On Premise Station Unit in this Practice.
Feature Module IV & On Premise Station Unit
Page 2