Table of Contents
Advertisement
Trillium Standard Practice
_..
--1
:,
Step 5.
Dial the 3-
to
7-digit access code of the feature you wish to change, then dial #.
_ /
(The feature access codes are given in the Programming
Prucrice).
Each digit
will be displayed in your set' s liquid crystal display as you dial it. The setting
currently programmed
for the feature will be displayed.
Access code 000 for
Hold Recall Time
Current setting for Hold Recall Time
Data Code = 2 so Hold Recall Time is
Programmed for 1 minute.
Step 6.
To change the current setting, dial the access code again, dial the data code of
the desired feature setting, then press the # key (data codes and possible feature
settings are also given in the
Programming
Pracrice).
Your selection will
appear in the display.
To
change current feature setting, enter
the access code again followed
by the data
code of the desired setting: then dial #.
New setting appears in the display.
If you enter an ineligible access or data code "--P" will be displayed.
If you
make an error simply re-enter the access and data codes correctly, then dial #.
Step
7.
Repeat Steps 5 and 6 for each additional feature you wish to change.
Feature Module II & Options Interface
Hardware
Page 10
Advertisement
Chapters
Table of Contents
