Mitel Panther II 820 System Manual page 52

Panther II 820/1032/2064-296
Replacing the Feature Module Cartridge
The following instructions detail the replacement of a Feature Module Cartridge in an
existing installation.
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.
Step 9.
Step 10.
Step 11.
Set the MEM. CLEAR Switch to the ON position. The MEM. CLEAR Switch
(dipswitch #2) is located on the right-hand side panel of the KSU.
Press the RESET Switch.
Set the MEM. CLEAR Switch to the OFF position. The system is now reset to
the default settings.
Ensure the BATTERY Switch for the KSU memory is in the ON position. The
Battery Switch (dipswitch #4) is located on the right-hand side panel of the
KSU.
Unplug the KSU
power cord. Telephone service will be disconnected.
Remove the Feature Module Cartridge protective cover. The protective cover,
located half-way down the right-hand side of the KSU, is secured by two screws
and two plastic expansion plugs. Loosen the two screws, pull back the plastic
expansion plugs and remove the protective cover.
Unplug the installed Feature Module Cartridge from the port on the side of the
KSU.
There are two small grooves on the Feature Module II Cartridge connector.
Holding the replacement Feature Module II Cartridge so that the grooves are
facing you, plug it securely into the port on the KSU (refer to the close-up
shown in Figure 2- 1).
Plug in the KSU power cord.
Replace the protective cover over the Feature Module II Cartridge, push in the
plastic expansion plugs, and tighten the two screws. Replacement of the
Feature Module Cartridge is complete.
You must now program the system with the customer' s feature selections. Refer
to the Programming Practice in the Panther II System Manual for instructions.
Programming instructions for the additional features provided by Feature Mod-
ule II software are given in this Practice.
Feature Module II & Options Interface Hardware
Page
3