Mitel Panther II 820 System Manual page 155

Trillium Standard Practice
A Speed Dial number can also be viewed at any time by following the
procedures given in Section 6, DISPLAY KEY.
SYSTEM TIME I DATE SETTING AND DISPLAY
When the Panther II system is connected, the display on each Panther II
Display Set will show - Please set time! If the Panther II Display Set is
used in the Master Attendant position (preprogrammed as Station lo), the
time and date for the entire system can be programmed from this Set.
The correct date, time and day of the week must be entered from the keypad
of the Master Attendant Set, using the procedures described in the Panther I.
Display Set User Guide - Master Attendant section.
Although the time must be entered using a 24-hour clock, the LCD of
Panther II Display Sets in the system will show the time in 12-hour format
(with "A" for a.m. and "P" for p.m.).
The system's time and date will appear on the LCD of each Panther II
Display Set in the system, when their Set is in its idle state.
TRANSFER RINGING DISPLAY
When Transfer Ringing is sent from a.station, the LCD of the transferring
station will show the line number that is being transferred on the top row of
the display. The word.TRANSPER will appear on the left side of the
bottom row, followed by the number of the station where the call is being
sent.
Features and Services
Page 62